전자부품 데이터시트 검색엔진
Selected language     Korean  ▼
부품명
         상세내용
Preview PDF Download HTML-1page HTML-10pages

AM29LV641ML101RFI 데이터시트(Datasheet) 34 Page - SPANSION

부품명 AM29LV641ML101RFI
상세내용  64 Megabit (4 M x 16-Bit) MirrorBit 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O Control
PDF  60 Pages
Scroll/Zoom Zoom In 100% Zoom Out
제조사  SPANSION [SPANSION]
홈페이지  http://www.spansion.com
Logo 

 34 page
background image
32
Am29LV641MH/L
December 21, 2005
DA TA SH EET
WRITE OPERATION STATUS
The device provides several bits to determine the status of a
program or erase operation: DQ2, DQ3, DQ5, DQ6, and
DQ7. Table 11 and the following subsections describe the
function of these bits. DQ7 and DQ6 each offer a method for
determining whether a program or erase operation is com-
plete or in progress.
DQ7: Data# Polling
The Data# Polling bit, DQ7, indicates to the host system
whether an Embedded Program or Erase algorithm is in
progress or completed, or whether the device is in Erase
Suspend. Data# Polling is valid after the rising edge of the
final WE# pulse in the command sequence.
During the Embedded Program algorithm, the device out-
puts on DQ7 the complement of the datum programmed to
DQ7. This DQ7 status also applies to programming during
Erase Suspend. When the Embedded Program algorithm is
complete, the device outputs the datum programmed to
DQ7. The system must provide the program address to
read valid status information on DQ7. If a program address
falls within a protected sector, Data# Polling on DQ7 is ac-
tive for approximately 1 µs, then the device returns to the
read mode.
During the Embedded Erase algorithm, Data# Polling
produces a “0” on DQ7. When the Embedded Erase
algorithm is complete, or if the device enters the Erase
Suspend mode, Data# Polling produces a “1” on DQ7.
The system must provide an address within any of the
sectors selected for erasure to read valid status infor-
mation on DQ7.
After an erase command sequence is written, if all
sectors selected for erasing are protected, Data# Poll-
ing on DQ7 is active for approximately 100 µs, then the
device returns to the read mode. If not all selected
sectors are protected, the Embedded Erase algorithm
erases the unprotected sectors, and ignores the se-
lected sectors that are protected. However, if the sys-
tem reads DQ7 at an address within a protected
sector, the status may not be valid.
Just prior to the completion of an Embedded Program
or Erase operation, DQ7 may change asynchronously
with DQ0–DQ6 while Output Enable (OE#) is asserted
low. That is, the device may change from providing
status information to valid data on DQ7. Depending on
when the system samples the DQ7 output, it may read
the status or valid data. Even if the device has com-
pleted the program or erase operation and DQ7 has
valid data, the data outputs on DQ0–DQ6 may be still
invalid. Valid data on DQ0–DQ7 will appear on suc-
cessive read cycles.
Table 11 shows the outputs for Data# Polling on DQ7.
Figure 8 shows the Data# Polling algorithm. Figure 21
in the AC Characteristics section shows the Data#
Polling timing diagram.
Figure 8.
Data# Polling Algorithm
DQ7 = Data?
Yes
No
No
DQ5 = 1?
No
Yes
Yes
FAIL
PASS
Read DQ7–DQ0
Addr = VA
Read DQ7–DQ0
Addr = VA
DQ7 = Data?
START
Notes:
1. VA = Valid address for programming. During a sector
erase operation, a valid address is any sector address
within the sector being erased. During chip erase, a
valid address is any non-protected sector address.
2. DQ7 should be rechecked even if DQ5 = “1” because
DQ7 may change simultaneously with DQ5.




Html 페이지

1  2  3  4  5  6  7  8  9  10  11  12  13  14  15  16  17  18  19  20  21  22  23  24  25  26  27  28  29  30  31  32  33  34  35  36  37  38  39  40  41  42  43  44  45  46  47  48  49  50  51  52  53  54  55  56  57  58  59  60 


데이터시트



관련 부품명

부품명상세내용Html View제조사
AM29LV640MH64 Megabit 4 M x 16-Bit/8 M x 8-Bit MirrorBit 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O Control 1 2 3 4 5 MoreSPANSION
AM29LV2562M512 Megabit 16 M x 32-Bit/32 M x 16-Bit MirrorBit 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O Control 1 2 3 4 5 MoreSPANSION
AM29LV641G64 Megabit 4 M x 16-Bit CMOS 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O Control 1 2 3 4 5 MoreSPANSION
AM29LV320MH32 Megabit 2 M x 16-Bit/4 M x 8-Bit MirrorBit 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O Control 1 2 3 4 5 MoreSPANSION
AM29LV256M256 Megabit 16 M x 16-Bit/32 M x 8-Bit MirrorBitTM 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/OTM Control 1 2 3 4 5 MoreAdvanced Micro Devices
AM29LV033MU32 Megabit 4 M x 8-Bit MirrorBit 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O Control 1 2 3 4 5 MoreAdvanced Micro Devices
AM29LV128MH128 Megabit 8 M x 16-Bit/16 M x 8-Bit MirrorBit™ 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O Control 1 2 3 4 5 MoreAdvanced Micro Devices
AM29LV640MU64 Megabit 4 M x 16-Bit MirrorBit 3.0 Volt-only Uniform Sector Flash Memory with 1 2 3 4 5 MoreAdvanced Micro Devices
AM29LV065M64 Megabit 8 M x 8-Bit MirrorBit 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O Control 1 2 3 4 5 MoreAdvanced Micro Devices
AM29LV642D128 Megabit 8 M x 16-Bit CMOS 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O Control 1 2 3 4 5 MoreAdvanced Micro Devices

링크 URL

ALLDATASHEET 가 귀하에 도움이 되셨나요?  [ DONATE ]  

Alldatasheet는?   |   광고문의    |   운영자에게 연락하기   |   개인정보취급방침   |   즐겨찾기   |   링크교환   |   제조사별 검색
All Rights Reserved© Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  , Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp  |   Russian : Alldatasheetru.com
Korean : Alldatasheet.co.kr   |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com  |   Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl