전자부품 데이터시트 검색엔진 |
|
LM2621 데이터시트(PDF) 3 Page - National Semiconductor (TI) |
|
|
LM2621 데이터시트(HTML) 3 Page - National Semiconductor (TI) |
3 / 10 page Absolute Maximum Ratings (Note 1) If Military/Aerospace specified devices are required, please contact the National Semiconductor Sales Office/ Distributors for availability and specifications. SW Pin Voltage −0.5 V to 14.5V BOOT, V DD, EN and FB Pins −0.5V to 10V FREQ Pin 100µA θ JA (Note 2) 240˚C/W T Jmax (Note 2) 150˚C Storage Temperature Range −65˚C to +150˚C Lead Temp. (Soldering, 5 sec) 260˚C Power Dissipation (T A=25˚C) (Note 2) 500mW ESD Rating (Note 3) 2kV Operating Conditions (Note 1) V DD Pin 2.5V to 5V FB, EN Pins 0 to V DD BOOT Pin 0 to 10V Ambient Temperature (T A) −40˚C to +85˚C Electrical Characteristics Limits in standard typeface are for T J = 25˚C, and limits in boldface type apply over the full operating temperature range of −40˚C to +85˚C. Unless otherwise specified: V DD=VOUT= 3.3V. Symbol Parameter Condition Typ Min Max Units V IN_ST Minimum Start-Up Supply Voltage (Note 4) I LOAD = 0mA 1.1 1.2 V V IN_OP Minimum Operating Supply Voltage (once started) I LOAD = 0mA 0.65 V V FB FB Pin Voltage 1.24 1.2028 1.2772 V V OUT_MAX Maximum Output Voltage 14 V V HYST Hysteresis Voltage (Note 7) 30 45 mV η Efficiency V IN = 3.6V; VOUT = 5V; ILOAD = 500mA 87 % V IN = 2.5V; VOUT = 3.3V; ILOAD = 200mA 87 D Switch Duty Cycle 70 60 80 % I DD Operating Quiescent Current (Note 6) FB Pin > 1.3V; EN Pin at V DD 80 110 µA I SD Shutdown Quiescent Current (Note 7) V DD, BOOT and SW Pins at 5.0V; EN Pin <200mV 0.01 2.5 µA I CL Switch Peak Current Limit 2.85 A R DS_ON MOSFET Switch On Resistance 0.17 Ω Enable Section V EN_LO EN Pin Voltage Low (Note 8) 0.15V DD V V EN_HI EN Pin Voltage High (Note 8) 0.7V DD V Note 1: Absolute maximum ratings indicate limits beyond which damage to the device may occur. Electrical specifications do not apply when operating the device outside of its rated operating conditions. Note 2: The maximum power dissipation must be derated at elevated temperatures and is dictated by Tjmax (maximum junction temperature), θJA (junction to am- bient thermal resistance), and TA (ambient temperature). The maximum allowable power dissipation at any temperature is Pdmax =(Tjmax -TA)/ θJA or the number given in the Absolute Maximum Ratings, whichever is lower. Note 3: The human body model is a 100 pF capacitor discharged through a 1.5 k Ω resistor into each pin. For Pin 8 (SW) the ESD rating is 1.5 kV. Note 4: Output in regulation, VOUT =VOUT (NOMINAL) ± 5% Note 5: This is the hysteresis value of the internal comparator used for the gated-oscillator control scheme. Note 6: This is the current into the VDD pin. Note 7: This is the total current into pins VDD, BOOT, SW and FREQ. Note 8: When the EN pin is below VEN_LO, the regulator is shut down; when it is above VEN_HI, the regulator is operating. www.national.com 3 |
유사한 부품 번호 - LM2621 |
|
유사한 설명 - LM2621 |
|
|
링크 URL |
개인정보취급방침 |
ALLDATASHEET.CO.KR |
ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |