1

NEW

2014.1

Low-Profile, Ultraminiature Lightweight SMT Coaxial Connectors - 0.94 or 1.2 mm Mated Height

X.FL Series

■Features

1. A Low mated height of 0.94 or 1.2

mm (maximum of 1.0 or 1.3 mm)

When connected this series delivers a world class

low mated height of 1.0 or 1.3 mm (see Figure 1).

2. Minimal mounting area required

which is the same footprint as our W.FL and W.

FL2 series. In addition, the same land patterns can

be used. (Note: The X.FL series has no mating

compatibility with the W.FL2 and W.FL series.)

3. Ultra lightweight

The world’s smallest and lightest class of coaxial

connectors

Receptacle: 3.2 mg

Right angle plug: 22.0 mg (068),14.4 mg (040), and 15.7 mg (032)

Plug receptacle: 5.5 mg

4. High frequency transmission

This series offers the high performance needed to

meet the requirements of many different

miniature devices, featuring a DC to 6 GHz

capacity. X.FL-LP(P)-068 supports up to 12 GHz.

5. Automatic board placement

This product is a v ailab le in embossed

packaging; this allows the plug and receptacles

to be automatically mounted.

6. The use of ultra-fine coaxial

(fluorinated resin insulated) cables

The use of ultra-fine coaxial (fluorinated resin

insulated) cables on these connectors offer the

ability to complete connections in small,

confined spaces with a smooth, easy operation.

7. Simple connector mating / unmating

Dedicated tools are available to ensure that proper

mating/unmating of this connector takes place.

●Connector mated condition

Mated height comparison (compared to conventional company products)

Fig. 1

■Product Specifications

Ratings

Nominal characteristic impedance

50ø

Operating temperature range -40°C to +90°C (RH 90% or less)

Frequency range

DC~6GHz

Storage humidity range

-30°C to +70°C (RH 90% or less)

Item

Specifications (for each plug type)

X.FL-LP-040

X.FL-LP-032(09)

X.FL-LP(P)-068

X.FL-PR-SMT1-2

1. Contact

resistance

(Center) Maximum of 20 mø

(Outer) Maximum of 10 mø

(Center) Maximum of 25 mø

(Outer) Maximum of 25 mø

(Center) Maximum of 25 mø

(Outer) Maximum of 10 mø

(Center) Maximum of 25 mø

(Outer) Maximum of 15 mø

2. V.S.W.R. (*)

1.3 or less (DC to 3 GHz)

1.4 or less (3 to 6 GHz)

1.3 or less (DC to 3 GHz)

1.4 or less (3 to 6 GHz)

1.3 or less (DC to 3 GHz)

1.4 or less (3 to 6 GHz)

1.7 or less (6 to 12 GHz)

1.3 or less (DC to 3 GHz)

1.5 or less (3 to 6 GHz)

3. Insulation resistance

4. Withstanding voltage

200 V AC, 1 minute

*V.S.W.R. Measurement System (plug type)

The above V.S.W.R. specification values were measured using the measurement system shown below.

X.FL-R-SMT-1

X.FL-LP-040

X.FL-PR-SMT1-2

X.FL-R-SMT-1 X.FL-R-SMT-1

Note 1:Cable type connectors were measured with SMA

conversion adapters attached to both ends of the

harness product of a suitable 100 cm cable.

Note 2:Board type connectors were mounted to a 50

glass epoxy board and measurements were

conducted with SMA conversion adapters

attached.

Test Port Cable

Network

 Analyzer

Test

 Set

Test

 Port

D.U.T

Termination