www.ti.com

PARAMETER MEASUREMENT INFORMATION

B. Waveform 1 is for an output with internal conditions such that the output is low, except when disabled by the output control.

Waveform 2 is for an output with internal conditions such that the output is high, except when disabled by the output control.

C. All input pulses are supplied by generators having the following characteristics: PRR

D. The outputs are measured one at a time, with one transition per measurement.

G. All parameters and waveforms are not applicable to all devices.

5, 10, 15, 30 pF

0.15 V

± 0.1 V

± 0.1 V

± 0.15 V

± 0.2 V

± 0.3 V

5, 10, 15, 30 pF

0.1 V

5, 10, 15, 30 pF

0.1 V

5, 10, 15, 30 pF

0.1 V

5, 10, 15, 30 pF

0.15 V

5, 10, 15, 30 pF

0.3 V

Output

Waveform 1

S1 at 2

(see Note B)

Output

Waveform 2

S1 at GND

(see Note B)

0 V

≈0 V

VOLTAGE WAVEFORMS

ENABLE AND DISABLE TIMES

LOW- AND HIGH-LEVEL ENABLING

Output

Control

2

GND

TEST

S1

From Output

Under Test

(see Note A)

LOAD CIRCUIT

S1

GND

5 k

Ω

5 k

Ω

2

SN74AUP1G07

LOW-POWER SINGLE BUFFER/DRIVER

WITH OPEN-DRAIN OUTPUTS

SCES591A – JULY 2004 – REVISED JULY 2005

(Enable and Disable Times)

Figure 4. Load Circuit and Voltage Waveforms

7