전자부품 데이터시트 검색엔진 |
|
STBC08PMR 데이터시트(PDF) 11 Page - STMicroelectronics |
|
STBC08PMR 데이터시트(HTML) 11 Page - STMicroelectronics |
11 / 17 page STBC08 Application information 11/17 -00 is Precharge Mode (Trickle charge mode) or Charge Mode. VCC is higher than VUVLO and RPROG is connected to the PROG pin. - 01 is STANBY MODE (charge completed) or SHUTDOWN MODE (RPROG not connected). - 11 supply is not sufficient. 6.5 PROG pin Charge Current Program, Charge Current Monitor and Shutdown Pin. The charge current is programmed by connecting a 1% resistor, RPROG, to ground. When the device is charging in constant current, the value of voltage on this pin is 1.0V. In other conditions, the voltage on this pin can be used to measure the charge current using the following formula: IBAT = (VPROG/RPROG)*1000 The PROG pin is used to shut down the device, disconnecting the program resistor from ground a 1µA current flows to pull the PROG pin high. If the value of this Pin is 1.21V (shutdown threshold voltage), the device enters Shutdown mode and the input supply current drops to 25µA. Driving this pin to voltage beyond 2.4V a current of 35µA flows into the device from PROG pin. 6.6 Programming charge current The RPROG resistor is used to set the charge current value. The battery charge current is 1000 times the Prog pin current value. The program resistor and the charge current are calculated using the following formula: RPROG=1000*VPROG/IBAT; The charge current out of the BAT pin can be monitored through the PROG pin voltage using the following equation: IBAT=(VPROG/RPROG)x1000 6.7 BAT pin Charge Current Output pin. It provides charge current to the battery and regulates the final float voltage to 4.2V. An internal precision resistor is used as a feedback loop to compare the VO with the reference. 6.8 Charge termination A charge cycle is terminated when the final float voltage is reached consequently the charge current falls to 1/10th of the programmed value. The charge is over when the PROG pin voltage falls below 100mV for longer time than tTERM (~1ms). The charge current is latched off, the device enters in standby mode and the input supply current drops to 200µA. |
유사한 부품 번호 - STBC08PMR |
|
유사한 설명 - STBC08PMR |
|
|
링크 URL |
개인정보취급방침 |
ALLDATASHEET.CO.KR |
ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |