A

Bushing

Back-shell

Cable

Contacts

Strain relief clamp

Washer

Solder

Insulator/contact assembly

Pre-solder

Conductor portion

B

4

Outline of assembly

Process

1

2

a. Pass the strain relief clamp, washer, bushing, and hood over the cable, in this order.

b. Prepare the cable and conductors per the dimensions in Table 1.

c. Bend the exposed conductor to the B dimension as indicated in Table 1.

d. Pre-solder the exposed conductor and solder it as shown to the exposed contact.

Note: Use care not to damage the conductor’s insulation.

a. Place over the contact/insulator assembly (in the following order:Back shell, bushing, washer, strain relief clamp).

b. Tighten the Locking ring and Cable clamp to the torque values per Table 2.

c. Tighten the set screw to a torque value of 0.3-0.4 N-m

HRS recommended tool: PB205/1.27 (CL150-0066-3)or equivalent.

d. Using screwdriver tighten the two strain relief clamp screws until both sides of the moveable part are in contact with the cable clamp.

A

B

18-10 Size

Table 1

22-22 Size

24mm

13mm

33mm

15mm

The contents of this catalog are current as of date of publication. Contents are subject to change without notice for the purpose of improvements.

5-23,OSAKI 5-CHOME,SHINAGAWA-KU,TOKYO 141-8587,JAPAN

PHONE: 81-3-3491-9741, FAX: 81-3-3493-2933

http://www.hirose.com

®

Locking Ring

Cable Clamp

Table 2

3 to 3.5N • m

5 to 6N • m

4.5 mm min.

Cable

Strain relief clamp

Back-shell

Locking ring

Screw

Clamp

Washer

Bushing

Set screw

(Hexagonal hole opposite side 1.27 mm)

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.

All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.