STANDARD

MICROCIRCUIT DRAWING

SIZE

A

5962-87719

DLA LAND AND MARITIME

COLUMBUS, OHIO 43218-3990

REVISION LEVEL

E

SHEET

9

DSCC FORM 2234

APR 97

4. VERIFICATION

4.1 Sampling and inspection. Sampling and inspection procedures shall be in accordance with MIL-PRF-38535,

appendix A.

4.2 Screening. Screening shall be in accordance with method 5004 of MIL-STD-883, and shall be conducted on all devices

prior to quality conformance inspection. The following additional criteria shall apply:

a. Burn-in test, method 1015 of MIL-STD-883.

(1) Test condition A, B, C, or D. The test circuit shall be maintained by the manufacturer under document revision level

control and shall be made available to the preparing or acquiring activity upon request. The test circuit shall specify

the inputs, outputs, biases, and power dissipation, as applicable, in accordance with the intent specified in method

1015 of MIL-STD-883.

b.

Interim and final electrical test parameters shall be as specified in table II herein, except interim electrical parameter

tests prior to burn-in are optional at the discretion of the manufacturer.

TABLE II. Electrical test requirements.

MIL-STD-883 test requirements

Subgroups

(in accordance with

MIL-STD-883, method 5005,

table I)

Interim electrical parameters

(method 5004)

1

Final electrical test parameters

(method 5004)

1*, 2, 3

Group A test requirements

(method 5005)

1, 2, 3

Groups C and D end-point

electrical parameters

(method 5005)

1

* PDA applies to subgroup 1.

4.3 Quality conformance inspection. Quality conformance inspection shall be in accordance with method 5005 of MIL-STD-

883 including groups A, B, C, and D inspections. The following additional criteria shall apply.

4.3.1 Group A inspection.

a.

Tests shall be as specified in table II herein.

b.

Subgroups 4, 5, 6, 7, 8, 9, 10, and 11 in table I, method 5005 of MIL-STD-883 shall be omitted.