Typical Application Information

General application guidelines and hints for differential driv-

ers and receivers may be found in the following application

notes:

AN-214, AN-457, AN-805, AN-847, AN-903, AN-912,

AN-916.

Power Decoupling Recommendations:

Bypass caps must be used on power pins. High frequency

ceramic (surface mount is recommended) 0.1 µF in parallel

with 0.01 µF at the power supply pin. A 10 µF or greater

tantalum or electrolytic should be connected at the power

entry point on the printed circuit board.

01264506

FIGURE 5. Driver Single-Ended TRI-STATE Waveforms

01264507

R

01264508

FIGURE 6. Typical Driver Connection

www.national.com

5